TeleWell TW-EA200, Manual

Page: 43 / 91

TW-EA200/500 ADSL modeemi/reititin ja palomuuri
6
2.3 The Rear Ports
The rear panel of the Router provides access to the AC power adapter cord connection as well as
the port connections.
TW-EA500
TW-EA200
2.4 Cabling
Through USB Port
The product can be used as a Network Adapter on your PC. That means you do not have to
install a network adapter first on your PC before connecting the ADSL Modem/Router. Just
connect the supplied USB cable to the USB port of the ADSL Modem/Router and connect the
other end to the PC.
Make sure that your ADSL Modem/Router and PC are turned on. On the front of the product is a
bank of LEDs. As a first check, please verify that the PWR, USB and ADSL SYN LEDs are lit.
As long as the cables are connected and the LEDs are lit normally, follow section
“3.1.1
Installing the USB Driver”
below to setup this device.
Through Ethernet Port
The Router may be connected to any 10/100BASE-T Ethernet LAN or Ethernet concentrating
device. Connection to an Ethernet concentrating device such as a switch or hub should use
standard twisted-pair cable with RJ-45 connectors. The dedicated RJ-45 port on the Router are a
crossed (MDI-X) connection ports. Follow standard Ethernet guidelines when deciding what
type of cable to use to make this connection.
Use straight-through cable when connecting the Router to a normal (MDI-X) port on a switch or
hub. Use crossed cable when connecting it to an uplink (MDI-II) on a hub or switch. When
connecting the Router directly to a PC or server use a straight-through cable. A valid connection
will be indicated by the Link LED indicator corresponding to the connected port.
As long as the cables are connected and the LEDs are lit normally, follow chapter 3
“Configuration”
below to modify the network settings.