T
E L E P H O N I C S
C
O R P O R A T I O N
TM115007 REV A (04/07)
2-17
USE OR DISCLOSURE OF DATA CONTAINED ON THIS PAGE IS SUBJECT TO THE
RESTRICTION ON THE TITLE PAGE OF THIS DOCUMENT
.
C
O M M U N I C A T I O N
S
Y S T E M S
D
I V I S I O N
The SLAVE automatically tries to re-logon to the same MASTER. If successful the operator will be
notified with a SynVoice message “LOGON OK”. Otherwise the operator will hear a “NEG
RESPONSE” tone.
If the unit does not successfully logon to a network within approximately two minutes, the unit’s
power is automatically turned off. Before turning off the power the operator is notified with
SynVoice message “AUTO POWER OFF”.
2.8.5 Key-Click
Every key pressed generates a key-click sound to the headset.
2.8.6
Power-On BIT Failure
If any errors are encountered during the power-on BIT testing, the LED indicates MALFUNCTION.
If this occurs the unit requires servicing and should be taken out of service.
2.9
TPT CHECK OUT PROCEDURE
The following should be performed before using the unit(s):
Ensure that the unit uses fresh alkaline cells or newly charged NiMH cells.
Ensure that one unit is started as a master on an unused channel. Confirm that other TPTs, on
the same channel can successfully log on to the master.
