T
E L E P H O N I C S
C
O R P O R A T I O N
TM115007 REV A (04/07)
2-13
USE OR DISCLOSURE OF DATA CONTAINED ON THIS PAGE IS SUBJECT TO THE
RESTRICTION ON THE TITLE PAGE OF THIS DOCUMENT
.
C
O M M U N I C A T I O N
S
Y S T E M S
D
I V I S I O N
If logon fails due to a mismatch of system configuration, the operator will hear a SynVoice message
“CONFIGURATION ERROR” in the headset. This is followed by a “NO SERVICE” tone, which is
repeated until next logon try.
The unit tries to logon for approximately two minutes. If unsuccessful, the user is notified by
SynVoice “AUTO POWER OFF” and the power is automatically turned off. The operator can
access the start-up menu and change channels until either the unit successfully logs on to the network
or it powers down.
2.8 SETTINGS
When the unit has logged on to a network, the operator typically has access to the following settings
with consecutive presses of the
M
key:
CHANNEL [channel list]
VOX [on/off]
KEY LOCK [on/off]
LED [normal, NVG, high, time, or off]
ORDER CHANGE MASTER
ORDER SYNCHRONIZE ACCESS POINT
The actual SynVoice menu a user hears is dependant on the configuration installed in the TPT (or
DPT). Some configurations do not have all these messages, others include more SynVoice messages.
Consult the appropriate configuration addendum for details. The
M
key is used for cycling between
the available menu selections.
The * is used for changing the settings of the selected item. When a setting has been changed,
PTT
is
used for confirming the new setting.
If the settings menu has been accessed and no further action is taken, after a few seconds the unit
exits the menu and the operator will hear a “MENU EXIT” tone in his headset.
2.8.1.1
CHANNEL Setting for TPT
Changing the channel when the unit is MASTER of the network is not recommended since the action
will disconnect all logged on operators.
To change the channel:
Press and release the
M
button until the SynVoice announces the CHANNEL setting, e.g.,
“CHANNEL ONE”.
Press and release * to step through the channel list. If * is held down for more than 0.5
seconds a “LONG KEY CLICK” will be heard instead of the ordinary key click. One long
key click corresponds to ten steps in the channel list. When * is released a SynVoice
message informs the operator of the selected setting, e.g., “CHANNEL ONE”. If the selected
channel is not the desired channel, press * again.
