T
E L E P H O N I C S
C
O R P O R A T I O N
TM115007 REV A (04/07)
2-15
USE OR DISCLOSURE OF DATA CONTAINED ON THIS PAGE IS SUBJECT TO THE
RESTRICTION ON THE TITLE PAGE OF THIS DOCUMENT
.
C
O M M U N I C A T I O N
S
Y S T E M S
D
I V I S I O N
5.
Off – LED is always off. No visible status is available, including power. This setting is not
normally recommended.
The LED settings cycle through; “LED NORMAL”, “LED HIGH”, “LED NVG”, “LED TIME”, and
“LED OFF”.
Press and release the
M
button until the SynVoice announces the LED setting, e.g. “LED
NORMAL”.
Press * to cycle through the selection list of LED settings, one key click corresponds to one
step in the selection list. When * is released a SynVoice message informs the operator of the
selected setting, e.g., “LED NVG”. If the selected setting is not the desired one, press *
again.
To confirm the setting press
PTT
. If the setting is not confirmed within a few seconds of the
change, the menu will be exited without any changes.
2.8.1.5
ORDER CHANGE MASTER Setting
Changing the MASTER unit of the network will temporarily disconnect all logged on operators.
Order Change Master is used to switch the MASTER unit of a network. It swaps the roles of
MASTER and SLAVE between the issuing SLAVE and the current MASTER. This should only be
employed when TPTs are part of a standalone network (no TAP or DPT).
From the SLAVE unit, press and release the
M
button until the old SLAVE unit emits a
SynVoice message “ORDER CHANGE MASTER”.
Press and release PTT once to initiate the change setting. When PTT is released a SynVoice
message, “ORDER CHANGE MASTER OK”, confirms the change to the operator. At the
same time, everyone on the network is alerted to the impending change via the SynVoice
message “AUTO CHANGE MASTER”.
The new MASTER unit then begins a network logon procedure. The successful logon is
confirmed to the operator via the SynVoice message “LOGON OK”.
Within one minute all other units on the network, including the old MASTER unit that is now
a SLAVE, re-logon to the network of the new MASTER. The successful logon is confirmed
to the operator via the SynVoice message “LOGON OK”, and communication can then
continue as before.
2.8.1.6
ORDER SYNCHRONIZE ACCESS POINT Setting (Changing TAP Channel)
This setting is used only when there is a connected TAP MASTER unit in the network. For a
description of this setting, see Paragraph 4.4.
