20
Track Button
To enter into track setting in PTZ mode
Wiper Button
To enable wiper function in PTZ mode
Light Button
To enable light function in PTZ mode
Clear Button
To return to the previous interface
Fn2 Button
Unavailable temporarily
Info Button
Get information about DVR like firmware version, HDD information
To
control
playback.
Play/Pause/Stop/Previous
Section/Next
Section/Rewind/Fast Forward
Snap Button
To take snapshots manually
Search Button
To enter into search mode
Cut Button
To set the start/end time for backup in playback mode
Backup Button
To enter into backup mode
Zoom Button
To zoom in the images
PIP Button
To enter into picture in picture setting mode
Note:
You shall press P.T.Z button to enter into PTZ setting mode, choose a channel and press P.T.Z button again to hide the
P.T.Z control panel. Then you can press preset, cruise, track, wiper or light button to enable the relevant function.
Operation processes with remote controller to control multi-DVR
The default device ID of the DVR is 0. It’s not necessary to reset the device ID when a remote is to be used to control a single
DVR. However when controlling multiple DVRs with multiple remote controllers, you would need to configure the device ID.
Please refer to below steps:
•
Activate remote controller to control the DVR: Turn the IR sensor of the remote controller towards the IR receiver on the front
panel, press the number key 8 twice on the remote, then input device ID of the DVR to be controlled (Range from: 0-65535;
the default device ID is 0) and press ENTER to confirm.
You can check the device ID of a DVR from System Setup
Basic
Device ID. You can also set multiple DVRs with the same
device ID. However this can cause interference if the DVRs are kept close to each other.
Summary of Contents for JN308
Page 25: ...25 Fig 3 3 Live Playback...
Page 33: ......
Page 49: ...DVR User Manual 41 Fig 4 42 Cruise Setting Modify Cruise Line Fig 4 43 Track Setting...
Page 74: ...66...
