Teledyne waverunner mxi-a series, Getting Started Manual, Page: 32 / 128

WaveRunner Xi-A and MXi-A Oscilloscopes
24 922138-00 Rev A
Displaying Signals/Traces - Vertical
Setup
Turn On Channels
Connect a signal to a channel (we’ll assume you connected to channel 1 in this
example and that the channel was not already ON).
Press the channel 1 button on the front panel to turn on channel 1. The button
lights and the descriptor label for that channel are shown.
If the signal is not on the grid, press the AUTO trigger button and adjust
Horizontal and Vertical front panel controls to adjust the settings and display
the signal, or simply press the AUTOSETUP button to quickly bring most
repetitive signals onto the grid.
If you need to change probe attenuation, coupling, or bandwidth limiting,
open the channel setup dialog for channel 1 by touching the descriptor label
for channel 1.
Press this button twice if it is not the active trace.
Or, use the Vertical

Channel 1 Setup selection from the menu bar to open
the channel 1 setup dialog: