Teledyne waverunner mxi-a series, Getting Started Manual, Page: 29 / 128

Getting Started Manual
922138-00 Rev A 21
B

Post-trigger Delay - This is indicated by a left-
pointing arrow below-left of the grid. Pre-
trigger delay is indicated by a right-pointing
arrow below-right of the grid.

Trigger Level - This indicator is located at the
right edge of the grid. It tracks the trigger level
as you reposition the trace up or down, or
change scale. When triggering is stopped, a
hollow arrow indicates where the new level
ends up when triggering resumes.
Push the
L
EVEL
knob to reset the level to 50%.

Zero Volts Level - This indicator is located at
the left edge of the grid. Change the zero volts
level by turning the
V
ERTICAL
O
FFSET
knob. Push
the knob to reset the indicator to the middle
of the grid.
Trace Descriptors
Vertical and horizontal trace descriptor labels are displayed below the grid.
They provide a summary of your channel, timebase, and trigger settings.
Adjust these settings by touching the respective label (its corresponding setup
dialog is then shown).
Channel trace labels show the vertical settings for
the trace, as well as cursor information if cursors
are in use. In the title bar of the label are also
included indicators for (SinX)/X interpolation,
waveform inversion (INV), deskew (DSQ),
coupling, bandwidth limiting (BWL), and averaging
(AVG). These indicators have a long and short
form: