M-412-064 Chapter 3: Installation Instructions
TELEDYNE TAPTONE
33
3.6 Electrical Power Connections
WARNING!
– All AC power electrical connections should be done by a certified
electrician. Improper connections may cause serious injury or death.
3.6.1 AC Power Connections
NOTICE!
– All T4000 systems ship from the factory set to 115V power input. Follow the
procedures below to select the AC power input for you installation.
AC Power Requirements: 100-120VAC OR 200-240VAC, 1-Phase, 3.0Amps, 275Watts
1. Set the 24V power supply ac input power selector switch to the appropriate setting
based on you AC power source. This supply is located in the control box.
115V = (100 to 120VAC)
230V = (200 to 240VAC)
Figure 3-17 AC Power Selector Switch
2. Connect the (neutral L1) wire to L1 terminal on the top of the AC power switch.
Connect the (line L2) wire to L2 terminal on top of the AC power switch.
3. Connect the (PE earth ground) to the upper right box stud labeled PE. This ground
wire must be the only wire placed on this box stud for PE.
Power Source Input
Select: 115V or 230V
24V Power Supply
