M-412-073 Chapter 3: Installation Instructions
TELEDYNE TAPTONE
19
3.2.2 Conveyor Mount Frame Installation (CMS)
26-1/2” (673mm)
17” (431mm)
1-1/2” (38mm)
Square Tube
Figure 3-2 Conveyor Mount Stand Dimensions (CMS)
1. Assemble the frame assembly as shown in Figure 3-3.
2. Place the frame assembly in the inspection area and mark the hole locations for the
frame mounting bolts. Make sure that holes are positioned where mounting hardware
is clear of any obstructions or working components of the conveyor.
3. Drill four 11/32
” (8.73mm) diameter holes on each side of the conveyor for the frame
mounting bolts.
4. Install the frame assembly using the hardware listed below:
For conveyors 3” (76mm) to 7” (177mm) wide use both conveyor spacer blocks
and 5/16 x 1 ¾” hardware provided.
For conveyors over 7” (177mm) wide use the 5/16 x ¾” hardware provides
without the spacer blocks.
5. Make sure the vertical posts are perpendicular to the conveyor table top.
6. Place the junction box in the mounting location next to the frame assembly and mark
the hole for drilling.
7.
Drill four 17/64” (6.75mm) holes in the conveyor for the junction box mounting
hardware.
