Page 3-73
Ethernet communica-
tions problem
Incorrect, disconnected
or faulty cable.
Check a network patch cable is connected from
XS31 to a live network outlet.
Replace faulty cable.
Ethernet link is
not active.
On the Ethernet connector (XS31), check:
Yellow LED is continuously lit to show link is
active.
Green LED flashes to show traffic is reaching the
SC200.
Incorrect communica-
tions settings.
Check that IP address and other settings in
SC200 are correct.
Check that the correct IP address is used in the
web browser address bar.
To configure an SC200 for Ethernet communica-
tions from the keypad,
1. Go to
Settings
>
Setup.
2. Enter the
IP Address
,
Subnet Mask
and
Gateway Address
assigned by the
network administrator.
3. If required, set
HTTP Access
to
Enabled
for
web browser access, or set
HTTPS Access
to
Enabled
for secure web access.
To configure an SC200 for Ethernet communica-
tions using
DCTools,
1. Connect using a USB.
2. In DCTools go to
Configuration
>
Communica-
tions
.
3. Under
Ethernet
, enter the
IP Address
,
Subnet
Mask
and
Gateway Address
assigned by the net-
work administrator.
4. If required, under
HTTP (Web)
, set
HTTP
Access
to
Enabled
for web browser access, or set
HTTPS Access
to
Enabled
for secure web
access.
Check that
HTTP Access
or
HTTPS Access
is
enabled.
SC200 serial communi-
cations are disabled.
“Check that S3P Access is enabled.” on page 72
Password required to
change settings (using
DCTools or PowerMan-
agerII).
“To set a Write Access Password,” on page 72
Table 8 - Troubleshooting issues and actions: SC200
Problem
Possible cause
Required action
