Tele
Corder
# TCwL-B4, V2.43, Revision 4, USA
13
.Existing Main ID & Wanted Main ID:
This is the Master Password and is not available to view.
.Existing 2
nd
Password:
The 2
nd
password created by the user can be used to unlock access to the
LAN as well as the Master Password (original recorder ID) if it is locked (password protected).
.LAN Access Locked:
Yes/No. Select if the LAN access is password locked (protected).
When editing and testing settings is complete, you should check the box to
Save default settings file
to
save the default settings (as a template).
Make necessary changes for the logger’s line parameter settings (VAR modes etc.).
.Port 1-4:
Checked if VAR mode is wanted, default is
audio activation
.
.VAR Voltage Threshold:
Define the VAR sensitivity, Levels 1-4, default is
mid sensitivity (2)
.
.VAR Turn Off Delay:
Define
time
to
wait
for
audio
before
turning
off,
levels
1-4,
default is
12 sec
.
.VAR Time Out:
Define the Max length of call, Levels 1-4, default is
20 min. default (0)
.
.Caller ID Settings:
All selected unless erratic characters result. USA standard is
FSK
.
.Audio Recording Mode:
Recommended setting is the default, default is
Small file good audio (2)
.
After editing, you can click the
Change Device Settings As Wanted
button to save the new settings
into the device.
NOTE: Be aware that the new settings will take effect after the device restart (power off and on).
The new settings will be saved in files named
TCwLSettingsDefault.ept
and
TCwLSettingsUser.ept
.
The files are saved to your PC. You may load these settings back into the logger as necessary.
It is very important to check all settings before restart.
Quit this application and launch again to check and verify your settings.
NOTE:
Most settings can be changed via the USB or LAN connections once the unit is installed. You
can force the new settings remotely via the
Reset by IP
and then
Change Device Settings as Wanted
.
4.2
Tele
Corder
Settings that can only be accessed via LAN connection to PC
Most recorder settings and functions that can be setup via LAN are
the same as setting up and operating via USB (see manual Section 3).
When you open the
Tele
Corder
software and it connects to the
recorder via LAN, the lower left corner of the software window will
show as with the image on the right instead as what shows when
connected via USB connection as shown in manual Section 5.1.2.
Clicking on the
Settings For Auto Upload, Refresh, RTC
button provides access to the functions only
available via LAN and will open the window shown below (see Section 5.1.27).