12
Tele
Corder
# TCwL-B4, V2.43, Revision 4, USA
If the recorder cannot be found via the LAN, the IP address of the unit can be entered into the “Connect
Directly Using Wanted IP” box to search for the specific IP address. If your IP address range is within the
default range of the unit (192.168.1.200) you will not need the USB connection to access the
TCwL-B4
.
If the recorder cannot be found via the LAN, connect a USB cable between a PC and the back of the
recorder, then run the
Reflash Utility
(V1.55 or higher) and edit the device settings.
When finished, be sure to click on the
Change Device Settings
button.
To lock the
new settings into memory, power must be cycled
(power the recorder down and up).
When done, disconnect the USB and run the
Reflash Utility
again. When the
Reflash Utility
finds the device, you are ready to run the
Tele
Corder
software and access the recorder via
the LAN connection.
When the
Reflash Utility
(V1.55 or higher) is open and the device is found over the LAN, port settings
can be changed using the
Reset by IP
command. Find the device over the LAN, make your setting
changes, select the “Reset by IP” button then select the “
Change Device Settings As Wanted
” button.
Close the SW and reopen to verify changes.
4.1.1
Reflash Utility Application Notes (Version 1.55):
TCwL-B4
can be connected via USB or LAN. The utility will check for recorders from USB at boot
stage automatically (first). If no USB is detected, you can force it to search for the recorder over the LAN
via the
Find the Device Over the LAN
button. The device default IP will have to be within the same range
as the network for this to work.
The Direct IP input field for direct connection and setting can be used if the device is not found over the
LAN. Enter the IP and select find.
If you have a problem reading the device, you may check the right-bottom corner box to
Load default
settings file
(factory defaults).
When the device is successfully found, you can read the existing settings information from the device.
All these settings are copied into the
Wanted settings fields
.
Edit these as necessary for your application.
.F/W Version:
ex. FCwL4.05.
.Existing IP:
ex.
192.168.1.200.
.Subnet Mask:
ex.
255.255.255.0.
.Existing MAC:
ex.
00.16.76.5F.8E.A5.
.Port TC Access:
ex. 2008.
.Port UP Stream:
ex. 2009.
.Handy Player Support:
Yes (check mark for YES is default).