10
Tele
Corder
# TCwL-B4, V2.43, Revision 4, USA
NOTE:
If the
Tele
Corder
is connected to your network, the time can be set to synchronize with your PC
daily when the software is opened and at noon time and minimize the need to calibrate the RTC (see
Section 4.2).
3.6.8
Audio Recording Mode:
From this sub-button you can set the quality of recordings.
Mode 0 --- Large file, good audio.
8bit linear PCM mode used in the 1
st
generation recorders.
Mode 1 --- Tiny file, poor audio.
2bit ADPCM mode.
Mode 2 --- Small file, good audio (default).
3bit ADPCM mode. Default mode set from factory.
Mode 3 --- Large file, best audio.
8bit nonlinear PCM mode.
3.6.9
Limitation for List Displaying:
From this sub-button you can set the list display features to
speed up the list refresh process or to have more items displayed in the lists of recordings shown on your
PC in the main
Tele
Corder
program screen. The default setting is 2000 for fastest speed. You can select a
different number, such as 10000, 32768 or 65536, respectively. This selection is saved in software, not as a
hardware setting and will be reset to 2000 every time the software is closed.
3.6.10
Caller ID Detection Settings:
From this sub-button you can set (turn on/off) the caller ID
detection features.
Pre-Ring DTMF Detection:
If the local caller ID mode is DTMF and sent before the ring, you
must turn this feature on. Otherwise, if erroneous caller numbers are
sometimes received, you should turn this feature off.
Pre-Ring FSK Detection:
If the local caller ID mode is FSK and sent before the ring, you must
turn this feature on. Otherwise, if erroneous caller numbers are
sometimes received, you should turn this feature off.
Forced FSK Between Rings:
If
your
caller
ID
signaling
is
FSK and sent between the rings, you
must turn this feature on. This is the normal setting for North America.
3.6.11
About
Tele
Corder
PC S/W:
From this sub-button, you can see additional information about
the
Tele
Corder
software.
3.6.12
QUIT:
Use this sub-button to exit the
Hardware Information & Settings
window.
3.6.13 Notes:
1.
The above settings must be locked into the
Tele
Corder
hardware by restarting the
recorder. After any of the above settings are changed, they will not take effect until the
recorder is restarted by turning off or disconnecting AC power to the
Tele
Corder
, waiting
a minimum of ten seconds, and powering the
Tele
Corder
back on. Any changes made in
software should now be locked into the recorder’s internal memory.
2.
To avoid interruption of active recordings, you should only set the above items while the
recorder
is
idle. Wait until no channels are active or unplug inputs prior to changing settings.
3.
After the settings have been changed, check to make sure that the recorder is functioning
as expected.
4.
The
recorder
listens
for
outgoing
numbers
dialed
using
DTMF/touch-tone
signaling
and