Teldat BinTec Elmeg DECT200, User Manual

Page: 28 / 125

elmeg DECT200 Multicell System / en / elmegDECT200M_en / telephony.fm / 18.10.2013
V
e
rsion 1, 01.0
7
.2012
27 elmeg DECT200 Multicell System
bintec elmeg Making calls
Making calls
You can make calls using any handset registered to your elmeg DECT200 Multicell System.
Prerequisite: You are located in the cell of at least one of the base stations registered to the
telephone system.
The cells of the base stations together form the DECT wireless network of the telephone system.
You can initiate or answer calls on a handset across the whole wireless network and change cells
during a call (handover).
Prerequisite for handover: The base stations involved must be
assigned to the same cluster and must be synchronised (
£
page 65 ).
Each handset is assigned a send and receive connection (
£
page 75 ).
If your elmeg DECT200 Multicell System is connected to a PABX that permits the formation of
groups, VoIP connections can also be assigned to groups. In this case, you will also receive calls
on your handset that have been sent to your group number.
The elmeg DECT200 Multicell System uses a VoIP PABX or the services of a VoIP provider for
Internet telephony. The availability of some phone functions depends on whether they are
supported by the PABX/provider and whether they have been enabled. If necessary, you can
obtain a description of the services from the operator of your PABX.
Calling
~ c
Enter the number and press the talk key. The number is dialled.
Or:
c ~
Press and hold the talk key
c
and then enter the number.
Instead of the talk key
c
, you can also press the speaker key
d
on the handset to make a
call in speaker mode.
In this user guide, each of these variants is indicated by "Press the talk key
c
".
The dialled number is shown on the display.
Please note
Depending on the specifications of your PABX, you may need to dial an access code for calls
outside the area covered by your VoIP PABX (
£
page 82 ).
Please note
If you use VoIP to make a call to the fixed line network, you may also have to dial the area
code for local calls (depending on the PABX/provider). This is not necessary if the area code
is entered in the configuration on the DECT Manager and the
Activating the area code for
local calls using VoIP option is enabled (see Web configurator
£
page 82 ).