elmeg DECT200 Multicell System / en / elmegDECT200M_en / web-conf.fm / 18.10.2013
V
e
rsion 1, 01.0
7
.2012
77
elmeg DECT200 Multicell System
bintec elmeg
Configuring the system on the DECT Manager
Network Mailbox Configuration:
¤
Enter the
Call number or SIP name (URI)
for the network mailbox and activate the network
mailbox.
¤
If these settings are to apply to all configured handsets, click on
OK
.
Settings for codecs
The voice quality of VoIP calls is determined by the
used for the transmission. To increase
the quality, more data must be transmitted. Depending on the bandwidth of the DSL
connection, this can then lead to problems with the volume of data – especially if several VoIP
calls are made simultaneously – so that the transmission no longer takes place smoothly.
Both parties involved in a phone connection (caller/sender and recipient) must use the same
voice codec. The voice codec is negotiated between the sender and the recipient when
establishing a connection. You can select the voice codecs to be used for this VoIP account and
specify the order in which the codecs are to be suggested when a VoIP connection is
established.
¤
Select the required codecs and define the sequence in which they should be used.
The following voice codecs are supported:
¤
If these settings are to apply to all configured handsets, click on
OK
.
G.722
Outstanding voice quality. The G.722 wideband voice codec works at the same bit
rate as G.711 (64 kbit/s per voice connection) but at a higher sampling rate (16 kHz).
G.711 a law/G.711 μ law
Excellent voice quality (comparable with ISDN). The required bandwidth is 64 kbit/
s per voice connection.
G.726
Good voice quality (inferior to G.711). Your phone supports G.726 with a
transmission rate of 32 kbit/s per voice connection.
Summary of Contents for BinTec Elmeg DECT200
Page 3: ......
