Tekvox TEK-MHD44TP 79055, User Manual

Page: 24 / 28

6.4 TCP/IP Operation - Optional
The optional network port of TEK-M
HD44TP is used for sending commands using TCP/IP control.
These commands are sent the same as when using RS-232 control at TCP/IP port 4001 . There is no
Web based control for the unit. The Web interface is used for network configuration only.
6.5 IP Configuration
To connect a computer to the network port you must use a crossover network cable or network
switch. Set its IP address of the PC to the same IP VLAN as the default IP is address or the unit
(192.168.0.178).
Enter the IP address 192.168.0.178 into Internet Explorer; you will see the LOGIN page as below:
Enter the password
“88888”, and then you can enter the configuration page to configure the IP
port, including the IP reset, PW reset etc.
Note: Serial configuration cannot be changed.
Same IP section
but cannot be
192.168.0.178
http://192.168.0
.178