Tekvox TEK-MHD44TP 79055, User Manual

Page: 20 / 28

/+[Y]/[X]:******.
Send embedded RS-232 commands to device at
HDBaseT receiver.

Y is for RS-232 port (connect with RS-232 port of
HDBaseT receiver)
Value = 1,2,3,4,5,A,B,C,D,E,F,G or H
The value of Y is defined into the following
meanings (in a given baud rate depended by the
value of X):
a. Y = 1 , 2 , 3 or 4 , send this command to the
corresponding HDBaseT receiver to control far-end
device.
b. Y = 5 , send this command to all HDBaseT receivers
to control all far-end devices.
c. Y = A , B , C or D
d. Y = E , F , G or H
For items c or d , send this command, it will be
saved to the matrix switcher but taken without
action to corresponding HDBaseT receiver. And its
command function will be effective almost at the
same time when you send the command
PWON
(for item c ) or PWOFF (for item d ).
Note:
A
& E are for port 1.
B & F are for port 2.
C & G are for port 3.
D & H are for port 4.

X is for bound rate (Value ranges from 1 to 7, 1 is
for 2400, 2 for 4800, 3 for 9600, 4 for 19200, 5 for
38400, 6 for 57600 and 7 for 115200)

***** is for data ( Max length 48 Bytes )
The symbol
“.” is the end of one command. If there
are some symbols of
“.” in one command, this case
is allowed and the last one is the end.
%0801. Enable inputs with HDCP management.
%0800. Disable inputs with HDCP management.
%0900. Set as infrared carrier following mode.
%0901. Set as infrared carrier enforcing mode.
%0911. Reset to factory default.
%9951. Check the command sent by port 1 when PWON.
%9952. Check the command sent by port 2 when PWON.
%9953. Check the command sent by port 3 when PWON.
%9954. Check the command sent by port 4 when PWON.
%9955. Check the command sent by port 1 when PWOFF.
%9956. Check the command sent by port 2 when PWOFF.
%9957. Check the command sent by port 3 when PWOFF.
%9958. Check the command sent by port 4 when PWOFF.
%9961. Check the system locking status.
%9962. Check the status while in standby mode.
%9963. Check the working mode of infrared carrier.
%9964.
Check the IP address ( only for the PCB with
GUI ).