Tektronix WFM 601A, Service Manual

Page: 98 / 368

Adjustment Procedures
WFM 601A, WFM 601E, & WFM 601M Service Manual
5–7
The Adjustment Software provides a graphic user interface and assigns a number
of special keys to simplify calibration. Figure 5–3 shows an example display.
1
Tek WFM601M FULL ADJUSTMENT
WFM INTENSITY
STEP 6 of 64
F8 F9 F10 change Adj. Size
STEP 6. WAVEFORM DISPLAY INTENSITY
F1–HELP F2–SETUP F3–NEXT F4–BACK F5–RESTART F6–STEP F7–EXIT
1. ADJUST – WFM INTENSITY for normal display intensity.
2. Select VECTOR DISPLAY.
3. ADJUST – VECTOR INTENSITY for normal display intensity.
4. Select WAVEFORM DISPLAY.
5. Enter the LIN SEL MENU and select 1H.
<PAGE DOWN FOR MORE INSTRUCTIONS>
to adjust
VECTOR INTENSITY
JOB.NAME
to adjust
Adj. Size
X10
PREVIEW MODE
2 3 4 5 6
8 9 7 10 11
12
Figure 5–3: Typical display of the adjustment procedures
The display features are as follows:
1. The job name box appears only when the current procedure is a job you
saved and have loaded and resumed.
2. The function key box lists the active function keys that provide program
control during the adjustment procedure. The keys function as described in
the following list:
F1. Displays the Help Menu.
F2. Displays the Setup Window. The Setup window details the initial
equipment connections for that particular step. Only those connections listed
in the Setup Window should be in place when the step is started. All other
connections from previous steps should be removed.
F3. Advances the Adjustment Procedures program to the next step.
Display Features