Tektronix WFM 601A, Service Manual

Page: 92 / 368

WFM 601A, WFM 601E, & WFM 601M Service Manual
5–1
Adjustment Procedures
This section describes how to calibrate the waveform monitor to meet the
performance levels defined in the Specifications section. These procedures
require that you use the Adjustment Procedure software on the 3.5
inch disk
included with this manual.
This section is organized as follows:
H
Equipment Required
H
Using the Adjustment Software
H
Using the TG2000/DVG1 Opt S1 Generator
H
Adjustment Procedure
H
Circuit Board Adjustment Locations
H
Adjustment Procedure Illustrations
H
TV Generator Test Signals
Equipment Required
The following equipment and accessory items are required to perform the
adjustment procedures. The list includes the equipment specifications and
recommended equipment that meets these specifications. The procedure is
written assuming you are using the recommended equipment. If you use other
equipment, you will need to modify some equipment set up and control settings.
1. MSDOS Compatible PC
DOS 3.3 or higher.
Minimum 640 kbytes of RAM
3.5 inch/1.44 Mbytes high-density floppy drive
Free RS-232 Port
2. Test Oscilloscope with 1X and 10X probes
Vertical Amplifier:
300 MHz Bandwidth, 2 mV Sensitivity.
Time Base:
10 ns/div to 5 ms/div sweep, triggering to 150 MHz.
For example: Tektronix TDS540A Oscilloscope with TVTrig option and
P6109B 10X and P6119B 1X probes.