TYPE R PLUG-IN UNIT
F A C T O R Y
C A L I B R A T I O N
P R O C E D U R E
The following instruments and equipment are needled:
1 TYPE
5
>iiO-Series Oscilloscope
1 Test Scope (calibrated vertical)
1 Special Scope Input Adapter
1
$22
TERMINATING RESISTOR (B$2-R)
1
$2-2
cable
1
$-2
Test Load
1
2$-2
Test Load
1 Flexible plug-in extension
1
Short plug-in extension
1 Grounded Emitter Transistor Board
The 5^0-Series oscilloscope should be set up as follows unless otherwise stated:
HORIZONTAL DISPLAY
TRIGGERING MODE
TRIGGER SLOPE
STABILITY
TIME/CM
MULTIPLIER
TYPE 107
INTERNAL SWEEP (Type 5'Ul)
MAIN SWEEP NORMAL (Type
$k$)
AC SLOW
-INT
full right (cw)
1 pSEC
1
Use a
$2-2
cable, terminated with a
TERMINATING RESISTOR (B$2-R)
The "Vertical-System Electrical Center" of the 5^0-oeries oscilloscope should,
be determined in the following manner:
Using a TEST LOAD UNIT, depress the PRESS TO SHORT INPUT button and
observe the vertical level of the trace. If you use a Type
$3/^1’
Plug-in unit, jumper between pins
1
and 3 on the
16
-pin connector
and observe the vertical level of the trace. This level will be
referred to later in the calibration procedure.
January, 1959
R-l