Tektronix TPS2000 Series, Service Manual

Page: 24 / 106

Specifications
1- 4
TPS2000 Series Digital Storage Oscilloscopes Service Manual
Table 1- 1: Oscilloscope general characteristics (Cont.)
Horizontal
Sample Rate Range TPS2012 and TPS2014 TPS2024 p g
5 S/s to 1 GS/s 5 S/s to 2 GS/s
Waveform Interpolation (sin x)/x
Record Length 2500 samples for each channel
SEC/DIV Range TPS2012 and TPS2014 TPS2024 / g
5 ns/div to 50 s/div, in a
1, 2.5, 5 sequence 2.5 ns/div to 50 s/div, in a 1, 2.5, 5 sequence
n
Sample Rate and Delay
Time Accuracy
±
50 ppm over any
≥
1 ms time interval
Delta Time Measurement
Accuracy (Full Bandwidth) Conditions Accuracy
Single-shot, sample
mode
±
(1 sample in 100 ppm
×
r 0.6 ns)
>16 averages
±
(1 sample in 100 ppm
×
r 0.4 ns)
Sample interval = s/div
÷
250
Position Range 2.5 ns/div to 10 ns/div: (--4 div
×
s/div) to 20 ms g
25 ns/div to 100 s/div: (--4 div
×
s/div) to 50 ms
250 s/div to 10 s/div: (--4 div
×
s/div) to 50 s
25 s/div to 50s/div: (--4 div
×
s/div) to 250 s
Trigger
n
Trigger Sensitivity,
Coupling Sensitivity
n
Trigger Sensitivity,
Edge Trigger Type
DC CH1, CH2, CH3
1
, CH4
1
1 div from DC to 10 MHz,
1.5 div from 10 MHz to Full BW
EXT 1 V from 50 Hz to full BW
EXT/5 5 V from 50 Hz to full BW
EXT/10 10 V from 50Hz to full BW
Trigger Sensitivity, Edge Coupling Sensitivity gg y, g
Trigger Type, typical
AC Same as DC-coupled limits from 50 Hz and above
NOISE REJ Reduces the DC-coupled trigger sensitivity by 2 times for greater
than 10 mv/div to 5 V/div
HF REJ Same as the DC-coupled limit from DC to 7 kHz, attenuates
signals above 80 kHz
LF REJ Same as the DC-coupled limits for frequencies above 300 kHz,
attenuates signals below 300 kHz
1
Available only on 4-channel oscilloscopes.