Tektronix TLA715 Series, Service Manual

Page: 97 / 147

Removal and Installation Procedures
6- 34
TLA715 Dual Monitor Portable Mainframe Service Manual
4.
If necessary, use use the pliers to gently bend the metal tabs that hold the fan
to the rear chassis fan tray until the fan is firmly in position.
5.
Attach the hold-down bracket(s) to the rear chassis fan tray.
6.
Do the Rear Chassis Fan Tray installation procedure, page 6--31.
Cord Wrap Feet
You will need a screwdriver with a size T-15 Torx tip to perform this procedure.
Use the following procedure to remove the cord-wrap feet:
1.
Set the mainframe so the bottom is on the work surface and the rear panel
faces you.
2.
Do the Rear Chassis Fan Tray removal procedure, page 6--30.
3.
Orient the chassis fan tray so that the cord-wrap feet are on the bottom and
the fans are on the top.
4.
Press outward to unlatch the two tabs that connect each cord-wrap foot to the
chassis fan tray. (See Figure 6--18 on page 6--34.)
5.
Remove the cord-wrap feet.
Press tabs
outward
Cord-wrap feet
Fan tray
Figure 6- 18: Cord-wrap feet removal
Removal