Tektronix TLA715 Series, Service Manual

Page: 70 / 147

Removal and Installation Procedures
TLA715 Dual Monitor Portable Mainframe Service Manual
6- 7
Removing the Replaceable Hard Disk Drive
Complete the following steps to remove the replaceable hard disk drive from the
mainframe. You should always remove the hard disk drive before accessing any
of the replaceable components in the instrument.
CAUTION.
Do not remove the replaceable hard disk drive while the instrument is
powered on. You can permanently damage the replaceable hard disk drive if you
remove it while the instrument is powered on. Always power down the main-
frame before removing the replaceable hard disk drive.
1.
Power down the instrument.
2.
Press the latch on the side of the instrument as shown in Figure 6--1 to
unlatch the hard disk drive.
3.
Remove the hard disk drive from the instrument by pulling on the handle.
Figure 6- 1: Removing the replaceable hard disk drive
4.
To replace the hard disk in the cartridge, remove the four screws that fasten
the hard disk drive to the cartridge shown in Figure 6--2.
5.
Carefully remove the hard disk drive from the cartridge, and remove the
cable assembly from the connector on the hard disk drive.