Tektronix TLA715 Series, Service Manual

Page: 75 / 147

Removal and Installation Procedures
6- 12
TLA715 Dual Monitor Portable Mainframe Service Manual
Floppy Disk Drive
You will need a torque screwdriver with a size T-15 Torx tip and a Phillips #0 tip
to perform this procedure.
Use the following procedure to remove the floppy disk drive:
1.
Remove the trim ring.
2.
Do the Flat Panel Display Assembly removal procedure.
3.
Detach the data cable from J103 on the front panel interface board; there is a
locking latch on both the floppy disk drive and on the interface board
connectors.
4.
Remove the two screws securing the floppy disk drive assembly to the
chassis.
5.
Remove the floppy disk drive assembly.
6.
Remove the data cable from the floppy disk drive assembly.
7.
Use a small Phillips screwdriver to remove the two screws holding the
floppy disk drive to the bracket.
8.
Remove the floppy disk drive from the bracket.
To install the floppy disk drive, complete the removal procedures in reverse
order. When you reinstall the Phillips screws, tighten them to 4 in-lbs.
NOTE
. When you reinstall the data cable on the floppy disk drive assembly and
on the interface board, lift up the locking latch before you insert the cable in the
connector. When the cable is in place, apply pressure to the cable and push the
locking latch closed.
Removal
Installation