Tektronix TLA715 Series, Service Manual

Page: 69 / 147

Removal and Installation Procedures
6- 6
TLA715 Dual Monitor Portable Mainframe Service Manual
Equipment Required
Most parts in this mainframe can be removed with a screwdriver with a T-15
Torx tip. Table 6--1 lists additional tools that may be required to service the
instrument to the module level.
Table 6- 1: Equipment required to service the portable mainframe
Item number Item Description
1 Flat blade screwdriver Small flat blade screwdriver
2 Cutters Diagonal cutters (for removing cable ties)
3 Spudger tool Used for removing the trim ring
4 Torque screwdriver han-
dle Accepts Torx driver bits
5 T-15 Torx tip Torx drive bit for T-15 size screws
6 T-10 Torx tip Torx drive bit for T-10 size screws
7 Phillips screwdriver Phillips #1 screwdriver and 6-inch long shaft
8 Needle nose plier
9 Soldering iron, solder,
solder wick For replacing soldered components
10 Cable ties 4-inch tie-down straps (Tektronix part number
343-0549-00)
11 Scribe Scribe or jeweler’s screwdriver
NOTE
. When installing the screws, use a torque screwdriver and tighten the
screws to 8 in-lbs unless otherwise noted.