In Case of Problems
26
TLA 700 Series Installation Manual
The podlet replacement procedure consists of identifying the faulty podlet and
replacing it with a new one. A podlet replacement kit is available as an optional
accessory.
NOTE
. Refer to the TLA 700 Online Help for part numbers of the TLA 700
accessories.
Equipment and Required Material.
You will need the following equipment and
material:
Replacement podlet
Masking tape
Small diagonal cutters
Screwdriver with #1 Phillips tip
Replacement Procedure.
Perform the following steps to replace a faulty probe
podlet:
1. Identify and mark the faulty podlet.
2. Disconnect the probe from the logic analyzer and set the probe cable on a
clean working surface.
NOTE
. If you need to replace more than one podlet, replace the podlets one at a
time to avoid mixing them up.
Replacing Probe Podlets
Summary of Contents for TLA 711
