Performance veri
fi
cation
e.
You should see
Black Burst
on the menu. If you do not, press the left
(
◄
) or right (
►
) arrow button until
Black Burst
appears, and then press
the ENTER button.
f.
Press the
BACK
button twice to exit the menu.
10.
Set the reference format of the SPG8000 under test to NTSC Burst as follows:
a.
Press the
REF
button. You should see
REFERENCE: SOURCE
.
b.
Press the right (
►
) arrow button until you see
NTSC Burst
in the menu,
and then press the
ENTER
button.
11.
Set the
BLACK 1
output of the SPG8000 under test to NTSC as follows:
a.
Press the
BLACK
button. You should see
BLACK 1 : FORMAT
on
the menu display.
b.
Press the right (
►
) arrow button until you see
NTSC
in the menu, and
then press the
ENTER
button.
12.
Check the following and record Pass under
NTSC Functional Genlock and
Timing
in the test record if all conditions are met. If any of these conditions
are not met, record Fail.
Check that the EXT light on the front panel of the SPG8000 under test is
a steady green.
Check that the Timing display on the waveform monitor reads 0 lines of
offset and less than 0.1
μ
s of horizontal offset.
Check that the waveform in the Vector display on the waveform monitor
is stable and not spinning.
34
SPG8000 Speci
fi
cations and Performance Veri
fi
cation
