Tektronix SDA601, Service Manual

Page: 17 / 132

SDA 601 Serial Digital Analyzer 1--1
Specifications
Introduction
The material in this section is organized into two main groupings: the specifica-
tion tables and the supporting figures. The specification tables include:
H
General input and output signal characteristics and specifications
H
Physical and environmental specifications
The supporting figures (waveform diagrams and related data) follow the
specification tables.
Reference Documentation
The following documents were used as references in the preparation of these
specifications:
Recommendations and Reports of the CCIR, 1978; Transmission of Sound
Broadcasting and Television Signals Over Long Distances (CMTT).
IEEE Standard Dictionary of Electrical Terms, Second Edition (1977)
IEEE Standard 100--1977.
IEC 60B (Secretariat) 170, “Helical-scan digital composite cassette recording
system using 19 mm magnetic tape (Format D--2) (NTSC, PAL, PAL-M).”
ANSI/ISA S82 — Safety Standard for Electrical and Electronic Test,
Measuring, controlling, and Related Equipment.
CAN/CSA C22.2 No. 1010.1-92 — Safety Requirements for Electrical
Equipment for Measurement, control, and Labratory Use.
IEC1010-1 — Safety Requirements for Electrical Equipment for Measure-
ment, Control, and Laboratory Use (1990).
Performance Conditions
The Performance Requirements are valid if the instrument has been adjusted at
approximately 25
°
C, is being operated within environmental limits (see
Table 1--3), and has had a minimum warm-up of 20 minutes.