Installation Instructions
RM4000 Rackmount Kit
11
Install
Equipment Required:
Torque driver with T-15 and T-25 tips.
This section describes mounting the rackmount parts to the instrument.
NOTE
. Rackmount part appearance may vary from the illustrations.
1.
Install the left and right mounting plates on the instrument using four
6-32 x 0.250 inch pan head T-15 TORX-drive screws tightened to 8 in-lb.
See Figure 5.
Front case
assembly
Right mounting
plate
Left mounting
plate
Screw
Screw
Screw
Screw
Figure 5: Installing the left and right mounting plates
2.
Install the two handles using four 10-32 x 0.25 inch pan head T-25 TORX-
drive screws tightened to 16 in-lb. Handles should curve towards the sides of
the instrument. See Figure 6.
3.
Fasten the back support plate to the left and right mounting plates with four
6-32 x 0.250 inch pan head T-15 TORX-drive screws, lining up the dimples
