RM4000 Rackmount Kit
9
Installation Instructions
This section contains the procedures needed to rackmount a DPO4000 or an
MSO4000 series instrument.
Minimum Tool and Equipment List
The following tools are required to attach the rack-adapter kit hardware, install
cabling hardware, and mount the rack-adapted instrument into a standard
equipment cabinet. All tools are standard tools that are readily available.
Table 3: Tools required for rackmount installation
Name
Description
Screwdriver handle (magnetic)
Accepts 1/4-inch hexagonal head driver tips
No. 2 Phillips or PoziDriv tip
Phillips or PoziDriv-driver tip for number 2 size screw heads
T-10 TORX tip
TORX-driver tip for T-10 size screw heads (flathead)
T-15 TORX tip
TORX-driver tip for T-15 size screw heads
T-25 TORX tip
TORX-driver tip for T-25 size screw heads
1/4-inch wrench
Wrench or nut driver can be used to install slides
Torque driver
6.5 in long shaft; accepts 1/4-inch hexagonal head driver tips
These instructions are for qualified service personnel who are familiar with
servicing the product. If you need further details for disassembling or reassem-
bling the product, refer to the appropriate product manual. Contact your nearest
Tektronix Service Center or Tektronix Factory Service for installation assistance.
WARNING.
To prevent the rackmounted instrument from tipping forward onto the
operator, install the instrument so that the operator will be able to access all of
its rear-panel connectors without pushing down on the instrument.
Verify that the rack does not become unstable with the instrument fully extended.
Do not leave the instrument extended when finished accessing the rear panel.
WARNING.
To avoid electric shock, disconnect the power cord from the mains
power before removing the cover. Failure to do so could result in injury or death.
