Model 2380-500-30 Programmable Instruments
Section 3: Performance Verification
2380-500-30-905-01 Rev. A / November 2015
9
Equipment required
These procedures use external equipment to directly check warranted characteristics. The following
table lists the required equipment.
Table 1: Test equipment
Number Item
Minimum requirements
Example
1
Connectors
Connectors for connecting wire assemblies and test
resistors, item numbers 5, 6, 9, 10, and 11.
#10 fork lugs similar to Tyco part number
52951 (Qty. 6)
Stackable, gold-plated banana plugs/jacks
similar to Pomona model 4897-0, which are
used for lower current connections,
connections to the load resistors (items 10
and 11), and used for noise testing (Qty.14)
Sheathed banana jacks similar to Pomona
model 4834 to mount connectors on the
resistors (Qty. 4)
2
DC power source
The DC source output voltage must be greater than
electronic load’s rated voltage.
Keithley
2260B-80-40
3
Digital
Multimeter
With voltage measuring range from 100 nV to 1 KV
and DC resistance measuring range from 100
μΩ
to
100 M
Ω
.
For multi-points measurement application, user can
measure input signals up to 20 channels
sequentially with the help of an optional switching
board
Keithley Model
2000 DMM
4
High-current hookup wire (high-
current connections are indicated
with bold lines in the setup
illustrations)
18 AWG (minimum) hookup wire assemblies
To perform all tests, the following wire assemblies
are required to be installed:
#10 fork lug to #10 fork lug (Qty. 2)
Stackable banana to #10 fork lug (Qty. 2)
Stackable banana to bare wire (Qty. 2)
Wire lengths are optional.
5
Low-current hookup wire (low-
current connections are indicated
with light lines in the setup
illustrations)
22 AWG (minimum) hookup wires.
To perform all tests, the following wire assemblies
are required to be installed:
Banana plug to Banana plug (Qty. 2)
Bare Wire to stackable Banana (Qty. 2)
Bare Wire to Banana (Qty. 2)
Wire lengths are optional.
