Model 2306-LAN Communications and Firmware Upgrade Instructions
2
071377001
April
2022
LAN cable connection
Connect a LAN cable from your computer to the LAN port on the rear panel of the 2306-LAN.
Figure 2: Model 2306-LAN cable connection
Each device on a LAN (corporate or private) requires a unique IP address. Contact your corporate information
technology (IT) department for details about obtaining an IP address before you connect the 2306-LAN to a
corporate or private network.
Contact your corporate IT department for permission before you connect the 2306-LAN to a
corporate network.
When the 2306-LAN is shipped, the IP configuration is set to manual and is set to the following values:
Instrument IP address
: 192.168.0.2
Gateway
: 192.168.0.1
Subnet mask
: 255.255.255.0
These values persist through a power cycle unless they are changed or the LAN RESET button is selected. If
the LAN RESET button is selected, the TCP/IP mode is set to manual. For more detail on the LAN RESET
button, refer to the
(on page 3).
Configure your computer and the IP address of the instrument on the same network, as indicated in the
following graphic.