Teknoware TAPSA CONTROL TKT65, Installation And Maintenance Instructions Manual

Page: 31 / 53

VOT 34; Rev 1.81; EN; 11.12.2019
TKT65C
– Installation and maintenance
31
The third row shows the voltage level of the battery set. The fourth row shows the battery set charge
and discharge currents.
Figure 2. LCD after having received configuration data from the central battery system
LCD menu tree
When you press the SETUP button, the LCD menu tree is displayed. You can browse the menu by
pressing the +/- buttons. You can select four separate submenus from the menu. The submenus are
shown in Figure 3.
The luminaire test log contains a two-year test memory, or, alternatively, the test memory of the latest
730 tests.
The battery test log contains a two-year test memory, or, alternatively, the log of the latest 256 tests.
The error log contains entries for the latest 42 errors.
You can use the SETUP button to change the date and the time of the day, as well as start a
luminaire/battery test.
Figure 3. Main menu
Test history
When you select Browse luminaire tests, the display below is shown.
Luminaire test log
23.03.11 23:59 OK
22.03.11 23:59 ERROR
Figure 4. Luminaire test log
The example shows a test date and time, as well as the test result, OK or ERROR. You can browse
the log by pressing the +/- buttons. If you want to view the test results for a particular date, use the +/-
buttons to select the desired date, and then accept your selection by briefly pressing the SETUP button.
To move back to the higher-level menu from the test log, press the SETUP button.
A central battery system may house 1 to 3 changeover boards, each with 8 outputs. Each output circuit
may have 16 luminaires. If the central battery system makes use of more than one change over boards,
you can select the data for a desired board by first pressing the +/- buttons and then confirming your
selection by pressing the SETUP button. The symbols used in the display indicate the following.
O = OK
# = Error
? = Luminaire not recognised (a luminaire has been added; automatic configuration is not in operation)
- = Luminaire is not connected
23.03.2011 10:30
System status OK
Voltage level 243V
Discharge current 1.0A
Browse luminaire tests
Browse battery tests
Browse error log
Setup