Teikoku DynaPump LE Series, Instruction Manual

Page: 5 / 31

CAUTION
Dynapump LE Series are canned motor, sealless pumps that offer a low cost, off the
shelf, environmentally friendly alternative to sealed and single containment sealless
pumps. Care should be exercised upon installation, start up, removal and maintenance
of the pumps. Recommended safety equipment should be used at all times.
Prior to returning any Dynapump LE Series to the factory the following procedure must
be followed:
1. Return Authorization must be obtained from the factory.
2. The pump must be decontaminated and cleaned.
3. The pump must be accompanied by a Decontamination Form, completely
filled out and signed by a responsible individual at the customer’s facility.
(Refer to copy of Decontamination Form in the Appendix of the Instruction
Manual.)
It is recommend that, as a minimum, a set of bearings and gaskets be purchased for
each Dynapump LE Series installed. When ordering spare parts, please reference the
serial number and model designation indicated on pump nameplate. When ordering an
impeller assembly, specify the diameter which can be measured across the blade tips.
Dynapump LE Series purchased for a particular application should only be used for that
service. Metallurgy, bearing materials and motor size may not be compatible if used on
a different application. Consult your local, authorized Teikoku USA Inc / Chempump
representative or distributor, or contact the factory for confirmation.