Shine Plus Maxi Digi
User Manual
Version
0.0.9
Page 19 of 64
13.
Analog Operation
The onboard function decoder of the Shine Plus Maxi Digi is
delivered with analog DC operation enabled, and F0 activated for
both travel direction (bit 2 is set in CV29 and CV14 is enabled for
use of F0 function in both directions of travel. CV14 = 1 +3 = 4).
Connecting the board to an analog voltage, will activate all outputs
of the on board function decoder. If you want to activate other
functions in analog DC mode, they have to be defined in CV13 and
CV14. Prior to this, the mapping of the function has to be defined in
Chapter 10.
Only functions F0, F1-F14 can be used in analog DC mode.
14.
Consist operation
The on board function decoder of the Shine Plus Maxi Digi lighting
board can use the Advanced Consist functions. To activate this
feature, the consist address has to be set in CV19. When the content
of CV19 differs from 0, the decoder will perform functions that are
defined in CV21 and CV22 only if they are transmitted to the consist
address. All other functions will be performed while they are sent to
the base address (defined in CV1 or CV17/18).
Functions declared in CV21, CV22 will not be performed while they
are transmitted to the base address.
Consists is useful if we want to run two or more engines in the same
train (this means several mobile decoders), as well as multiple
traction and want to perform some of the functions individually for
each decoder, and other functions globally for all of the decoders.
Speed and direction commands will be sent to all decoders within the
same consist. In this way the headlights (of locomotives) and tail
