TeeJet Technologies ISOBUS IC18, User Manual

Page: 9 / 45

3
98-05204 R1 UK
OVER
VIE
W
SE
TUP
APPENDIX
GE
TTING ST
AR
TED
OPER
ATION
ISOBUS Job Computer : IC18 Sprayer
CHAPTER 2 – GETTING STARTED
• A firm touch is required when selecting a screen icon.
•
Settings are NOT automatically saved when selected. The ACCEPT KEY must be selected to save the setting. Select the
ESCAPE KEY to escape without saving settings and return to the previous menu.
• The console needs to be cycled off and back on when changing or attaching equipment to the system.
• The menu structure on your display might vary from the one displayed in this User Manual depending on the virtual terminal being
used.
START UP
Power is continuously supplied to the job computer. The virtual terminal will give access to the job computer options and operation.
Figure 2-1: Master Screen - Crop Sprayer Mode
Matrix VT Setup Key
IC18 Crop Sprayer
Master Screen Key
Other options as available on
ISOBUS system
APPLICATION MODE
The IC18 job computer is programed to be either a sprayer or NH3 applicator. This setting has been established before leaving the factory,
but it can be changed after purchase with assistance from TeeJet Technologies Customer Service or your local dealer through the OEM
setup menu options.
Figure 2-2: Crop Sprayer
C n t 1
5 . 0 4 2
4 7 0 l
0
b a r
1 . 1 4 h a
+ 5 %
1 3 11
l / h a k m / h
Figure 2-3: NH3 Applicator
C n t 1
0 . 0
0 . 0
0 . 0
0 . 0
0 k g N 0 . 0 0 h a
+ 5 %
1 3 11
k g / m i n
k g / h a
k m / h
k g / h a
This manual discusses specifically the functions and options in Crop Sprayer Mode. See the specific IC18 NH3 User Manual for functions
and options in NH3 Mode.