TeeJet Technologies ISOBUS IC18, User Manual

Page: 14 / 45

8
www.teejet.com
OVER
VIE
W
SE
TUP
APPENDIX
GE
TTING ST
AR
TED
OPER
ATION
ISOBUS Job Computer : IC18 Sprayer
CHAPTER 3 – MAIN SETUP IN SPRAYER MODE
Main Setup Mode configures the Counters, Job Parameters, Machine, User Interface, Communication and Help options.
NOTE: The menu structure on your display might vary from the one displayed in this User Manual depending on the virtual
terminal being used.
Figure 3-1: Main Setup Screen
Home Key
Back One Screen
Up One Option
Down One Option
Master Screen Key
Forward One Screen
MAIN SETUP MODE MENU STRUCTURE
| | | | | |
Counters
(pages 10-12)
Job Parameters
(pages 13)
Machine
(pages 14-20)
User Interface
(pages 21)
Communication
(pages 22)
Help
(pages 22-24)
Trip Filling Diagnostic
Campaign Operation About
Total Implement parameters – Section width
Export Counters Implement speed sensor – Calibrations Nozzle preset setup
Flow sensor Alarm configurations Regulation parameters
OEM
The OEM setup menu is password protected and the settings in this menu are directly related to the fitted OEM equipment. Refer to the IC18 Sprayer/NH3 OEM Setup
Manual for information regarding OEM settings.
Main Setup Screen
NOTE: Settings are NOT automatically saved when selected. The ACCEPT KEY must be selected to save the setting. Select the
ESCAPE KEY to escape without saving settings and return to the previous menu.
To access the Main Setup screens:
1. Select IC18 SPRAYER KEY from the Master Screen.
2. Select MAIN SETUP SCREEN KEY from the Home Screen.
3. Select from:
►Counters – used to provide an overview of various system counters:
◄ Trip – used to display information regarding area, distance, time and amount applied.
◄ Campaign – used to display information regarding area, amount applied and time for all trips
◄ Total – used to display information regarding area, amount applied, and time for all activity
◄ Export Counters – allows counter information to be exported in HTML or CSV format
►Job Parameters – used to configure application settings including active trip counter, application rate and nozzle type.
►Machine – used to configure machine settings:
◄ Filling – establishes the amount of material remaining in the tank and the density of that material.
◄ Operation – establishes Application Rate Step, Speed Source, and Simulated Speed
◄ Implement Parameters – establishes the Section Width, Nozzle Preset Setup and Regulation Parameters
◄ Calibrations – establishes either manual or automatic settings of the sensors
◄ Alarm Configurations – establishes alarms for CAN Speed Source Timeout, Active Trip Count Information mode and Tank
Content Minimum
◄ OEM – The OEM setup menu is password protected and the settings in this menu are directly related to the fitted OEM
equipment. Refer to the OEM Setup Manual for information regarding OEM settings.