P. 8
Tecshow Stratus Fazer |
English version
6. INSTALLATION
7. CONTROL MODES
Installing the Fazer
Remove all packing materials from the fog machine.
Check that all foam and plastic padding is removed,
especially in the nozzle area. Fill with Fog Liquid or
other high-quality water-based fog fluid. Any other
types of fluid can damage the unit. Be careful not to
exceed the maximum fluid level. DO NOT OVERFILL.
When filled, place cap back on liquid tank. Firmly
attach the remote control cable to the proper input
on the rear of the machine The unit can also be
operated at floor level or sitting on any regular sur
-
face as well. If the unit is to be mounted using the
bracket, it is important that the fog does not shoot
directly at any one’s face. Therefore, do not point
the nozzle in a direction that will aim directly at a
person. Whatever installation method you choose,
There are 2 ways to control the fazer:
1. Wireless remote control (stand-alone)
2. DMX512 (1 Channel)
Wireless remote control
1. You can use the Stratus fazer with a wireless
remote control.
2. Be sure to plug the receiver into the connector
(6) on the backside of the fazer.
3. Just press one of the two buttons to start fog-
ging, both buttons have the same function.
do not allow the unit to have more than a 15 degree
angle of inclination.
Always disconnect from electric mains power
supply before cleaning or servicing. Damages
caused by non-observance are not subject to
warranty.
Set Up and Operation
Before plugging the unit in, always make sure that
the power supply matches the product specifi
-
cation voltage. Do not attempt to operate a 120V
specification product on 230V power, or vice versa.
Always monitor tank fluid level as you are fog
-
ging. Running a fog machine with no fluid can
permanently damage the unit.
Multiple Stratus fazers
(DMX Control)
1.
Fasten the effect light onto firm trussing Leave
at least 1 meter on all sides for air circulation.
2. Always use a safety cable (ordercode
70140/70141).
3. Use a 3-p XLR cable to connect the Stratus
Fazers and other devices.
4.
Link the units as shown in (figure 3), Connect a
DMX signal cable from the first unit's DMX "out"
socket to the second unit's "in" socket. Repeat
