Tecnosicurezza DeadBolt T5100/D, Installation Instructions Manual

Page: 4 / 20

4 of 20 II_ DigiTech_05_eng
Installation instructions
DigiTech
Certifications
The updated product certifications are available on the official websites of Tecnosicurezza:
www.tecnosicurezza.it www.tecnosicurezza.es www.usatecno.com
Important notes
!

Before installing this product, please read carefully the installation and operating
instructions.

Locks can be installed in all traditional safes.

Locks have to be mounted on secure storage metal (preferred steel) units only.

Locks must be protected against external attacks, for this reason it is recommended to
install them on the door away from any through holes (except DeadBolt and MotorLock).

If locks are not properly protected by systems belonging to the safe (manganese plates,
glass plate, relocking, etc.) only DeadBolt and MotorLock locks can be mounted behind
the passage hole for the connection cable or the spindle.

Any electronic part must be properly protected and not easily accessible even when the
door is open.

Locks have been developed to work correctly in a temperature range from -5 ° C to + 50
° C and in an environment with non-condensing humidity between 25% and 90%.

The mounting dimensions are standard (magic module).

For keypad and lock installation, use only the screws provided by Tecnosicurezza. Any
other screw must be approved in advance.

Locks are supplied with metric (M6) mounting screws. Upon request, Imperial 1/4-20 UNC
format mounting screws are available.

The type of material and the length of the screws must, in any case, be selected so as to
guarantee long life and reliability.

Tighten the screws so that the lock is firmly fixed to the mounting surface
(recommended torque between 2,5 and 5,5 Nm).

The mounting surface must be perfectly flat.