II_DigiTech_05_eng
11 of 20
Installation instructions
DigiTech
DeadBolt and LatchBolt locks installation instructions
DeadBolt and LatchBolt locks are locks with, respectively, a dead bolt and a spring bolt, whose
block is carried out by a motor.
By entering a valid code, the lock electronic removes the blocking for 3 seconds and the
boltwork can be moved into open position by turning the spindle inserted in the lock.
The spindle can be connected to a knob, a handle or directly to the keypad if equipped with a
rotation kit. When the spindle is brought to the locked position, the bolt comes out ensuring
the lock is locked.
The DeadBolt and LatchBol locks can be mounted in all four mounting directions (RH, LH, VU,
VD).
In the locked position, there should be approximately 1 mm clearance
between the lock bolt and the cavity in the blocking bar of the boltwork.
The bolt must be able to move freely without force being applied to it.
In open position, there should be a minimum of 3 mm and maximum
of 5 mm clearance between the lock bolt and the blocking bar of the
boltwork.
The maximum load applicable to the bolt must not exceed 1 KN. Contact Tecnosicurezza in case of
heavier loads.
The LatchBolt lock is specially designed to ensure self locking when the door closes.
T5101/S
The distance between the LatchBolt lock and the locking edge must be
between a minimum of 6 mm and a maximum of 10 mm.
