GB / IE - 1
5410.498.00
Part 1
Installation
ELECTRIC PASTA COOKER
General Instructions
The appliance referred to in this manual has been manufactured in
conformity to the following Directives:
2004/108/CEE
“Low Voltage”;
2006/96/CEE
“Electromagnetic Compatibility".
The appliance shall be installed by a qualified Technician according to
the regulations and directives in force in the country where it is
installed, as well as the instructions in this manual.
The appliance shall be used exclusively by trained personnel and only
for the purpose for which it has been designed.
The appliance should be checked once a year by a qualified technician.
Remove the packaging form the appliance as well as the protective
plastic sheet, and, if necessary, remove traces of glue with a suitable
solvent. To dispose of the packaging, follow local directives. The
technical specifications of the appliance can be found on the data plate
located inside the control panel, which can be removed by loosening the
two screws below the panel.
When installing the appliance, all the regulations in force shall be
observed, such as:
All applicable national laws in effect;
All regional or local regulations, such as building codes;
Directives and regulations of the local electrical energy supplier;
Accident prevention regulations in effect;
Fire prevention regulations;
Applicable I.E.C. regulations.
The appliance should be installed under an extractor fan
for the removal of cooking fumes.
If the appliance is installed near walls, panels or kitchen furniture, etc.,
they must be made of fire-proof material; if they are not, they must be
protected with fire-proof material which insulates from heat.
Connection to the mains
Before connecting the appliance to the mains, compare the electrical
set-up data on the data plate to the characteristics of the local electrical
energy supply.
The self-adhesive polyester data plate is behind the
control panel
“
T
” (fig.3) inside the appliance.
Adjust the height of the appliance by regulating the feet, and make sure
that it is perfectly level.
The appliance is equipped with a connecting cable to which the installer
must connect a circuit breaker which cuts off the flow of electricity in all
poles; the distance between the open contacts must be at least 3mm.
The circuit breaker must be easy to reach.
The cable must not be placed near heat sources.
The area around the cable must not have a temperature above
50°C.
If the cable must ever be replaced, consult the wiring diagram
attached.
The electric supply cable must not have specifications inferior to
type H07 RN-F. It must have a cross-sectional area of at least
5×1.5mm
2
tab. (fig.1).
To reach terminal board “
M
” (fig.2), remove the control panel “
B
” (fig.2)
by loosening the screws on the lower part of the panel. To connect the
power cable, follow the indications given in the wiring diagram enclosed
with this manual.
Loosen the cable clamp “
Al
” (fig.1) and insert the power cable
For this purpose, there is a screw marked with the symbol
near the
terminal board to which the earthing conductor must be connected.
The appliance must also be connected to a unipotential earthing circuit.
This connection can be made using the screw marked with the symbol
placed under the appliance.
The equipotential wire must have a section of 10mm
2
.