TECNOELETTRA s.r.l.
via D.Vioni n.5 – 42016 S. Rocco - Guastalla (RE) Tel.+39.0522.832004 Fax.+39.0522.832012
mail:
web:
www.tecnoelettra.it
Cod. doc. MT2550038-rev.1.0-IT-GB.doc
42 / 56
3.2 - General connection drawing (with factory programmation)
Terminal board J1:
1.1…1.4 Mains voltage (see Menu 06)
Terminal board J2:
2.1…2.4 Generator voltage (see Menu 07)
Terminal board J3:
3.1…3.6 Current transformers inputs (CT ratio P02.01)
Terminal board J4:
4.0 - 4.1 - 4.2 Mains contactor (check programmable outputs Menu 13)
4.3 - 4.4 Generator contactor (check programmable outputs Menu 13)
Terminal board J5-6:
5.3 - 5.4 - 5.5 Global alarm
6.1 + Battery (common for outputs relay, 12/24Vdc)
6.2
Siren alarm output (check programmable outputs Menu 13)
6.3 Stop electromagnet
(check programmable outputs Menu 13)
6.4
Start/crank output
(check programmable outputs Menu 13)
6.5
Fuel electrovalve (check programmable outputs Menu 13)
6.6
D+ excitation on batterycharger alternator (not necessary)
Terminal board J7:
7.1 + Battery (12/24 Vdc see menu 03)
7.2 - Battery (12/24 Vdc see menu 03)
Terminal board J8-9:
8.1 Emergency button (see programmable inputs Menu 12; if the
button is not used, connect input to terminal 72, - battery)
8.2 Remote start (see programmable inputs Menu 12; it works only in
AUT mode)
8.3 Generator protection (see programmable inputs Menu 12)
8.4 Auxiliary input (see programmable inputs Menu 12)
8.6 Remote stop (see programmable inputs Menu 12; it works only in
AUT)
9.1 Engine temperature alarm (see programmable inputs Menu 12)
9.2 Oil pressure alarm (see programmable inputs Menu 12; se non
previsto collegare con morsetto 72 - batteria)
9.3 Fuel reserve alarm (see programmable inputs Menu 12)
Terminal board J10:
10.1 W signal from batterycharger alternator (not necessary)
10.2 Permanent magnet type batterycharger alternator (not necessary)
10.4 D+ on pre-excitation batterycharger alternator (not necessary)
