Tecnoalarm Tecnofire TFA2-596, Installation Manual, Page: 59 / 64

TFA2-596 - TFA4-1192
59
PROTECTION AGAINST DEEP DISCHARGE
Automatic battery disconnection for Vbat <8.9V DC
Protection against deep discharge disabled
END-OF-SERIAL BUS
Insert on the last device of the serial bus
LED Signaling
LED RUN
Green Flashing = normal operatiing conditions
LED LINE Red On = PSTN telephone line busy
LED USB
Red On = USB cable connected
Key jumpers
Special high-level procedures, such as fi rmware upgrade, reset of the con fi guration etc., require the use of speci fi c jumpers
available on the CPU board of the telephone communicator:
JP1 WDT - The jumper disables the WATCHDOG circuit of the telephone communicator.
In normal operating conditions, the jumper must always be open.
In some procedures, such as
fi rmware upgrade via serial port, the jumper must temporarily be closed.
JP2 RESET - The jumper is used to reset and restart the microprocessor.
In normal operating conditions, the jumper must always be open.
In some procedures, such as
fi rmware upgrade, the jumper must temporarily be closed.
JP4 BOOT - The jumper is used to perform the fi rmware upgrade via USB port.
In normal operating conditions, the jumper must always be open.
JP5 PROG - The jumper is used to perform the fi rmware upgrade of the telephone communicator.
In normal operating conditions, the jumper must always be open.
During
fi rmware upgrade via serial port, the jumper must temporarily be closed.
Supervision of jumpers
The telephone communicator oversees the open or closed state of the jumpers to prevent that they are forgotten in the wrong
position after use, causing potential undesirable behaviors or malfunctioning of the telephone communicator.
The telephone communicator noti
fi es the condition of anomaly to the control panel.
SPECIAL PROCEDURES
JP1 - WDT
Leave open during normal operating conditions (jumpers reserved for fi rmware upgrade and reset the con fi guration)
Supervised
position
JP2 - RESET
JP4 - BOOT
JP5 - PROG
SW1 Address
Address SW1.1 SW1.2 SW1.3 SW1.4 SW1.5 SW1.6 Address SW1.1 SW1.2 SW1.3 SW1.4 SW1.5 SW1.6
0 OFF OFF OFF OFF OFF OFF 9 ON OFF OFF ON OFF OFF
1 ON OFF OFF OFF OFF OFF 10 OFF ON OFF ON OFF OFF
2 OFF ON OFF OFF OFF OFF 11 ON ON OFF ON OFF OFF
3 ON ON OFF OFF OFF OFF 12 OFF OFF ON ON OFF OFF
4 OFF OFF ON OFF OFF OFF 13 ON OFF ON ON OFF OFF
5 ON OFF ON OFF OFF OFF 14 OFF ON ON ON OFF OFF
6 OFF ON ON OFF OFF OFF 15 ON ON ON ON OFF OFF
7 ON ON ON OFF OFF OFF 16 OFF OFF OFF OFF ON OFF
8 OFF OFF OFF ON OFF OFF
N.B. The address 0 disables the telephone communicator. Accepted addresses range from 1 to 16.
All the other addresses are reserved.