3. Pull the thread to thread guide 1(6), shown in Fig 3
4.Put the thread into thread clamp (9) after passing through the thread guide 1(6),
shown in Fig 4.
5. Wind the thread to thread guide 2 (7) from thread guide 1(6 )after passing
through the thread clamp (9), shown in Fig 5. 6
6.Threading the end of the thread through the take-up lever(4), shown in Fig 6
7.Threading the thread through the thread guiding spring1(11) after passing
through the take-up lever(4, shown in Fig7.
8. Wind the thread through the thread guiding spring 2(14) after passing through
the thimble ring (13), shown in Fig8.
9. Wind the thread end through thread
guiding spring 2(14) to the pinhole of the
sewing needle (16), shown in Fig9.
10.Threading can be assisted by the
threader (36), shown in Fig10.
Threading the steel wire of the threader (36) to pass through the pinhole of the
sewing needle (16) and then insert the thread into the steel wire of the threader
(36). Hold the thread end by hand and pull back the threader (36), and the thread
end will pass through the pinhole of the sewing needle (16).
Attention
1.
Make sure the thread pass through thread clamp (9). When the thread
passes through thread clamp (9), poke slightly the thread clamp (9) to make sure
there’s no thread jamming.
2.
It is strictly required to follow the above steps during threading.
Installation and extraction of Bobbin thread
10
