Technoline WT 482, Instruction Manual

Page: 15 / 66

ADJUSTABLE LO DIM LED BRIGHTNESS
When LO dim brightness is selected by pressing
once
, turn the knob at the right side to
adjust your desired LO dim LED brightness. Rotate downwards to reduce and upwards to increase
the Lo dim brightness. Note: HI LED brightness is not adjustable.
SETTING UP THE FM ANTENNA
Extend the FM wire antenna fully and vary the direction for best FM reception. Do not strip, alter or
attach to other antennas.
LISTENING TO THE FM RADIO
1. To turn on the radio, press
RADIO/SLEEP
once, the display shows “
ON
” and then the radio
frequency readings in
Mhz.
2. Press / to tune the radio to a desired station. Press and hold / to scan for the
next clear station.
3. To adjust the volume, press
VOL
once, the display shows “
L10
” , press / to adjust
volume from
L01
(minimum) to
L15
(maximum)
4. Press to turn off the radio.
Remark:
keep your radio away from fluorescent lamps or other electronic devices, which may cause
interference to the radio.
USING THE PRESET MEMORY
This clock radio features a total of 10 preset memories of FM stations. These allow you to preset your
favorite stations and access them quickly.
1. Turn on the radio and select a radio station you like to memorize.
2. Press and hold the
SET
until “
MEM
” LED appears and “
01
” flashes. Press
SET
once to
store Memory 1.
3. Press or to select another station you like to memorize. Then press and hold
SET
until
“
MEM
” LED appears and “
01
” flashes. Press once, “
02
” appears. Press
SET
once to
store Memory 02.
4. Repeat Step 2 to 3 to preset memories 3 through 10.
5. To access a preset station at any time, press the
SET
one at a time while the radio is on.
6. To edit a preset station, select another station and then repeat Step 2 to 4. This overrides
the original settings.
USING THE SLEEP TIMER
1. At normal time display mode, press the
RADIO/SLEEP
twice to enter the sleep mode. The
SL
LED appear and the sleep time “
05
” (5 minutes) flash on the display.