NAT COMMANDS
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
793
nat mapadd
Add an address mapping to a nat enabled interface.
SYNTAX:
nat mapadd
intf = <{loop|ipsec0|Internet|lan1|wan1|dmz1|
guest1}>
[type = <{napt|nat}>]
[outside_addr = <ip-range>]
[inside_addr = <ip-range>]
[access_list = <ip-range>]
[foreign_addr = <ip-range>]
[protocol = <{ah|egp|esp|ggp|gre|hmp|icmp|
igmp|pup|rdp|rsvp|tcp|udp|vines|xns-idp|6to4|
ipip} or number>]
[outside_port = <port-range>]
[inside_port = <port-range>]
[mode = <{auto|inbound|outbound}>]
[weight = <number{0-255}>]
[status = <{up|down}>]
where:
intf
The IP interface name.
REQUIRED
type
The type of mapping.
OPTIONAL
outside_addr
The outside (typically public) IP address (range for NAT).
OPTIONAL
inside_addr
The inside (typically private) IP address (range for NAT).
OPTIONAL
access_list
The range of inside addresses the mapping is restricted to.
OPTIONAL
foreign_addr
The range of destination addresses the mapping is restricted
to.
OPTIONAL
protocol
The IP protocol.
OPTIONAL
outside_port
The outside port number or range (only for NAPT).
OPTIONAL
inside_port
The inside port number or range (only for NAPT).
OPTIONAL
mode
The mode to create the portmap.
OPTIONAL
weight
The weight for the portmap.
OPTIONAL
status
The administrative state of mapping.
OPTIONAL
nickdj.co.uk