Technica Engineering CM Eth Combo, User Manual, Page: 43 / 57

CM Eth Combo

User Manual
43
Keep Awake Reason Bus :
This port is supervised. If on this port is communication, CM_E th_Combo can’t go
asleep.
This port is not supervised. The Capture Module can fall asleep even there is
communication on this port.
Section : It is a hexadecimal number. E.G “1A8”
It is a number assigned to any port separately. For further information see definition
of PLP-protocol. This value is used as VLAN-ID for the function
Use OuterVlan s in
C
HAPTER
4.5.1.4 .
BusID : It is a hexadecimal number. E.G “B0”
It is a number assigned to this port and the paired port (A is paired with B). For further
information see definition of PLP-protocol.
Enable Injection for this port :
If activate this function, you get access to a device directly connected on this
1000BASE-T1 Port by a GB-Port. After activating please apply the IP-address of the
connected device
in the field “ IP for Injection ” .
Note : Don’t forget to set “ IP for Injection ” on the specific GB -Port.
Note : Don’t forget to configure the field “ Maximal delay (bytes) for Injection ”
No Injection possible on this port
IP for Injection : This field is available if the box “ Enable Injection for this port ” is
checked. Please fill in the IP-Address of the device directly connected on this port and
you want to get direct access by the GB-port.
Maximal delay (bytes) for Injection :
This field is available if the box “ Enable Injection for this port ” is checked. Please fill in
a value many times higher than 512. The maximum is 1536 bytes. For higher
performance a small value is recommended.
This value is the maximum size of the possible inject frame, which is sent by the device
connected on the configure
d “ Output to ” GB -port.
Time Stamp : Timestamp in nano seconds [ns] resolution and accuracy of 40 nano
seconds [ns]
Messages Received : Counter for received messages on this port from the connected
1000BASE-T1-device
Messages with Error : Counter for received messages on this port from the connected
1000BASE-T1-device containing an error. For example, CRC errors.