GB
14
4.6.2 REMOTE CONTROL: HOW TO CHANGE FROM INFRARED TO WIRED
1. PREPARE THE REMOTE CONTROLLER
•
Detach the plastic cover of the remote controller terminal block.
•
Open the batteries compartment, remove the batteries and set microswitches 5 and 6 in OFF position.
•
Close the compartment without replacing the batteries (remote controller will be powered by wire).
2. CONNECTION
Use a tripolar electric shielded wire 0.5mm2, max. length 15m. The wires have not to be lighter than Mod.
H05VVC4V5-K (according to CEI 20-20 CENELEC HD21).
CONNECTING THE REMOTE CONTROLLER TO THE 5 POLES TERMINAL BLOCK INSIDE THE ELECTRICAL
PANEL AS FOLLOWS:
•
Remove the yellow “bridge” wire.
•
Connect the terminal that ends with PNK wires to the bottom terminal of remote controller terminal block (+
pole).
•
Connect the terminal that ends with VLT wire to the medium terminal of remote controller terminal block (IR).
•
Connect the terminal that ends with WHT wires to the upper terminal of remote controller terminal block (- pole).
ELIMINATE “BRIDGE” WIRE (YELLOW)
REMOVE THE BATTERIES
5P TERMINAL BASE INSIDE THE
ELECTRICAL BOX
5, 6 OFF
YEL
YEL/GRN
WHT
VLT
PNK
3742551181-I-TEC-CAW-GB.indd 14
3742551181-I-TEC-CAW-GB.indd 14
27/01/2015 13:55:36
27/01/2015 13:55:36
