25
18V is for Horizontal while 13V is for Vertical.
LNB 22 KHz:
Generally this is used to control 22KHz switch, typically
used for LNB with double L.O. in Ku band. “ON” is for high L.O and
“OFF” is for low L.O.
TS Standard:
there are two options for TS standards: DVB and ATSC.
Depending on the input module used, sometimes the parameters
may change; it is advisable to check through
www.lyngsat.com
for the
updated satellite parameters if utilizing a satellite delivered program
source.
DVB-T/T2 (Optional)
If the tuner is for DVB-T/T2 or 8VSB receive, it will change to the above (or similar)
interface when clicking the inputs menu. This page is to configure the parameters of
DVB-T/T2 receive. There are three parameters as following:
Mode:
to set DVB-T or DVB-T2 receiving.
Frequency:
to input the frequency that the receiver is appointed to
receiving..
Bandwidth:
There are three options: 6M/7M/8M. Set the corresponding
parameter according to the operator requirement.
DVB-C (Optional)
Regarding DVB-C parameters, user only needs to input the frequency, symbol
rate and QAM mode to scan and receive the input signal.
ASI
Area 3
Area 3
