Team Nisca Nisca PR5350, Operation Manual

Page: 42 / 64

39
6
- a) Input Roller
Before starting this operation,
please read the general advice
which appears in the beginning
part of this section.
Remove the Input Roller module
as explainedin Page 45 and
clean in the following procedure.
Wet and squeeze a piece of soft
cloth with alcohol for cleaning
OA equipment and wipe in the
direction as illustrated.
Rotate the roller slowly and
clean all surface. After cleaning,
wipe with a dry cloth and leave
about 1 minute to dry up before
reinstalling.
After wiping off, wait till it becomes completely dry before inserting it again.
6
- b) Cleaning of the card transport rollers in Flip Turn Block
Bef ore beginning thi s operation, please read the gener al advi ce whic h appears in
the begi nning part of this section.
◆
Open the top cover, rotate the whole
Flip Turn Module to the angle of
easy to clean as using green handle
as shown in the figure on right.
◆
Prepare the cotton swab and put a
few alcohol on it.
Touch the cotton swab to the surface
of rubber rollers, then rotate the
these rollers as using green disk
as shown in figure on right.
This cleaning is given for the all
white mold rollers paired with
rubber rollers as well.